iFlight XING-E Pro 2207 1800KV Motor | 4-6S 5-Inch Freestyle Motor | The FPV Project

The iFlight XING-E Pro 2207 1800KV is iFlight’s accessible-tier 5-inch freestyle motor — carrying the unibell design and quality components of the premium XING lineup into a more wallet-friendly package. Tuned specifically for 6S power, the 1800KV winding delivers strong, linear torque output suited to aggressive freestyle flying without the snap of higher-KV alternatives.

Why choose the XING-E Pro 2207 1800KV?

The XING-E Pro sits between budget no-name motors and premium-tier options — it uses the same N52H high-temperature magnets and NSK bearings as iFlight’s more expensive motors, but in a more cost-efficient package without sacrificing the things that actually matter for flight performance. The unibell design reduces flex under load and adds crash durability compared to traditional split-bell motors. Pair it with our AIO flight controller and ESC range for a complete 5-inch build.

This listing is for the 1800KV variant only — sold as a set of 4 motors (all CW thread, props lock with included flanged nylon nuts).

Key features

Unibell design

The Pro upgrade over the standard XING-E is the unibell bell architecture — a single machined piece rather than a press-fit assembly. This reduces bell flex under high load, improves concentricity, and adds meaningful crash durability at the most vulnerable point of the motor.

N52H high-temperature magnets

N52H-grade magnets are rated for higher operating temperatures than standard N52 magnets — maintaining consistent magnetic flux and motor performance during sustained high-throttle freestyle flying where cheaper magnets begin to lose output.

9x4x4mm NSK bearings

Larger 9x4x4mm NSK bearings compared to standard 9x3x4mm bearings used in many competing motors at this price — better load handling, lower vibration, and longer service life across repeated crash cycles.

Single-strand copper windings

Single-strand winding produces a more precise, consistent coil geometry compared to multi-strand alternatives — contributing to more predictable torque output and better motor-to-motor consistency across a set of four.

5mm hollow steel shaft

A 5mm outer diameter hollow steel shaft balances rigidity with weight — resistant to bending on hard prop strikes while keeping overall motor weight at 33.8g including wires.

Specifications — 1800KV